Visual Adjustments - Planmeca ProMax Technical Manual

USER PREFERENCE SETTINGS

2.4 Visual adjustments

From the list of User preference settings (i200) select Visual adjustments (i250).
In this mode you can adjust the Dynamic Exposure Control (DEC) settings (i25.1) and
Calibrate the Touch panel (i25.4).
The image taken can be previewed from the Preview Settings (i25.5) after taking the
exposure.
The 3D settings can be adjusted from the 3D display settings (i25.6).
Figure 9
2.4.1 DEC settings
DEC density can be adjusted on the DEC settings display (i251).
Figure 10
DEC density is expressed in percentage in comparison to DEC calibration value. The setting
can be adjusted between 20% (lower exposure values -> brighter image) and 200% (higher
exposure values -> darker image). The recommended setting is 100% (default setting)
NOTE DEC is available for panoramic and cephalometric programs. It is not available for
SmartPan programs (3D V2 / 3D s sensor + SmartPan).
Technical Manual
Chapter B - INFORMATION DISPLAYS
Planmeca ProMax B-7