Feature Program Control; Enable / Disable Features - Planmeca ProMax Technical Manual

FEATURE PROGRAM CONTROL

3 FEATURE PROGRAM CONTROL
From the list of information displays select Feature program control (i300). In this mode new
features can be added to the X-ray unit.
Figure 17

3.1 Enable / disable features

On the Enable/disable features (i310) display, touch the feature you wish to activate. Enabled
features will be marked with a green check mark. Confirm the selection by touching Done.
By touching the down arrow in the lower left corner more features will appear. On the next
display, touch the up arrow in the lower left corner to return to the previous display.
Technical Manual
Chapter B - INFORMATION DISPLAYS
Planmeca ProMax B-13