Factory Default Settings - Planmeca ProMax Technical Manual

Chapter B - INFORMATION DISPLAYS
To set the cephalometric exposure values select Set ceph parameters limits (i54.2). The
display shown below appears. Select the maximum and minimum kilovolt, and minimum
milliampere values with the arrow fields and touch the Done field.
Figure 41
To set the 3D exposure values select Set 3D parameters limits (i54.3). The display shown
below appears. Select the maximum and minimum kilovolt, and minimum milliampere
values with the arrow fields and touch the Done field.
Figure 42

5.5 Factory default settings

The Factory default settings (i550) will turn up only in case the memory card (RTC) has lost
its configuration and user settings or it has been replaced to a new PCB. In this case the
procedure should be done before using the X-ray unit.
B-28 Planmeca ProMax
SERVICE SETTINGS
Technical Manual