Policy-Map; Assign-Queue - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
The CLI command root is
To enter "Config-policy-map" mode, use the
from Global Config mode.
To enter "Config-policy-classmap" mode, use the
"Config-policy-map" mode.

13.4.1 policy-map

This command establishes a new DiffServ policy. The
sensitive alphanumeric string from 1 to 31 characters uniquely identifying the policy. The
type of policy is specific to the inbound traffic direction as indicated by the in parameter.
Note: The policy type dictates which of the individual policy attribute commands
Note: The CLI mode is changed to Policy-Map Config when this command is
Format
Mode
13.4.1.1 no policy-map
This command eliminates an existing DiffServ policy. The
name of an existing DiffServ policy. This command may be issued at any time. If the
policy is currently referenced by one or more interface service attachments, this delete
attempt fails.
Format
Mode

13.4.2 assign-queue

This command modifies the queue id to which the associated traffic stream is assigned.
The queueid is an integer from 0 to n-1, where n is the number of egress queues supported
by the device.
Quality of Service (QoS) Commands
policy-map
are valid within the policy definition.
successfully executed.
policy-map <policyname> in
Global Config
no policy-map <policyname>
Global Config
v4.1, October 2008
.
policy-map <policy-name> in
class <class-name>
<policyname>
<policyname>
command
command from
parameter is a case-
parameter is the
13-17