Diffserv Policy Commands; Assign-Queue - NETGEAR ProSafe FSM7326P Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
To specify the match condition as a numeric value, one layer 4 port number is required.
The port number is an integer from 0 to 65535.
Format
Mode

13.4 DiffServ Policy Commands

Use the DiffServ policy commands to specify traffic conditioning actions, such as policing
and marking, to apply to traffic classes
Use the policy commands to associate a traffic class that you define by using the class
command set with one or more QoS policy attributes. Assign the class/policy association
to an interface to form a service. Specify the policy name when you create the policy.
Each traffic class defines a particular treatment for packets that match the class definition.
You can associate multiple traffic classes with a single policy. When a packet satisfies the
conditions of more than one class, preference is based on the order in which you add the
classes to the policy. The first class you add has the highest precedence.
This set of commands consists of policy creation/deletion, class addition/removal, and
individual policy attributes.
Note: The only way to remove an individual policy attribute from a class instance
The CLI command root is

13.4.1 assign-queue

This command modifies the queue id to which the associated traffic stream is assigned.
The queueid is an integer from 0 to n-1, where n is the number of egress queues supported
by the device.
Format
Mode
Incompatibilities Drop
13-16
match srcl4port {portkey | <0-65535>}
Class-Map Config
within a policy is to remove the class instance and re-add it to the policy.
The values associated with an existing policy attribute can be changed
without removing the class instance.
policy-map
assign-queue <queueid>
Policy-Class-Map Config
v1.0, March 2006
.
Quality of Service (QoS) Commands