Table of Contents
Advertisement
ICP DAS WISE User Manual
sending and CGI command receiving. In the CGI command receiving
function, administrator can set a set of account and password in the "CGI
Query Authentication Setting" section to protect the operation of the
WISE, then WISE will only receive the CGI commands with this
account and password information, perform the corresponding
operations, and ignore other CGI commands that do not with this
account and password information. The CGI Query Authentication
Setting page is as follow:
Blacklist and Whitelist Setting
WISE provides the mechanism of Blacklist and Whitelist to prevent the
intrusion from the unknown devices on the network. Administrator can
use the Blacklist function to prohibit the connection between WISE and
the devices from the specific IP or domain; or use the Whitelist function
to allow the devices from the specific domain to connect with WISE.
The setting page is as shown below:
To enable this function, please check "Enable" in the "Function Status"
field and select "Black List"or "White List" in the "Type" field. After
press the "Add" button in the List field, WISE provides three ways to set
up the content of the Blacklist and Whitelist according to the network
environment as "Single IP Address", "Subnet" and "IP Address Range".
Please refer following.
http://wise.icpdas.com
Figure 5-13：CGI Query Authentication Setting Page
Figure 5-14：Blacklist and Whitelist Setting Page
45
Advertisement
Table of Contents
