Table of Contents
Advertisement
ICP DAS WISE User Manual
6.6 Remote Modbus TCP Module Setting
WISE
allows
WF-2000/IR/DL modules and general Modbus TCP Modules. Through
Modbus TCP protocol, it enables to read or write 4 types of Modbus data
(Coil Output, Discrete Input, Input Register and Holding Register) from the
Modbus TCP modules. And by WISE IF-THEN-ELSE rule engine, it allows
to perform automation control operation on the modules. And with SCADA
software, it also allows monitoring and control of the Modbus TCP modules
which connect with the WISE. The Modbus TCP Slave Module setting page
is shown as follow:
Please Note: The LAN interface on WISE allows connections to at most 16
devices ((P)ET-7000/WISE-7100/WF-2000/IR modules or Modbus TCP
modules).
6.6.1 Add ICP DAS module or Modbus TCP Module manually
The user could add the (P)ET-7000/WISE-7100/WF-2000/IR/DL
module or Modbus TCP modules manually one by one, the steps are as
below:
i. No: The number will be the order that the I/O channel data of the
Modbus TCP module being stored in the WISE Modbus Table. The
range is 1~16.
ii. IP: Allows modification of the IP address, Port and NetID of this
Modbus TCP module, make sure the IP, Port and NetID setting are
the same as the settings of the module. If the setting is not accurate,
the connection for WISE to the module will be failed.
iii. Select the module name: For ICP DAS (P)ET-7000/WISE-7100/
WF-2000/IR/DL modules, the user could select the default model
name from the dropdown list. Please input the nickname for other
Modbus TCP modules manually.
http://wise.icpdas.com
connections
Figure 6-43：Remote Modbus TCP I/O Module Setting page
to
ICP DAS
(P)ET-7000/WISE-7100/
93
Advertisement
Table of Contents
