Table of Contents
Advertisement
ICP DAS WISE User Manual
The settings steps are as below:
i Click the "CGI Receiving" Tab on the right-top corner of the CGI
Command Setting page.
ii Click on "Add" button in the "Variable Name" field to add variables
which will be used in the CGI command. After add the variables, the
system will display the usage of the variables in the receiving CGI
command in the red rectangle area as below for reference. Following
is an example.
User creates two variables "DO" and "AO" in the variable adding
process, the system will show the usage format of the CGI command
as "http://192.168.100.102/dll/cgi.dll?DO=value&AO=value". It
means the remote network devices can send the CGI command to
WISE (with IP address 192.168.100.102). After WISE receives the
CGI command, it will immediately update the value of "DO" and
"AO" variables in WISE kernel engine. If the "DO" or "AO"
variables are used in the IF condition statements of WISE logic rules,
WISE will also evaluate the result of the IF condition and trigger the
related the THEN/ELSE actions.
Please Note: Because CGI Query Authentication Setting in the
"Security
(&id="Username"&password="Password") into the CGI command.
iii Click on "Add" button in the "Source Address" field. It means WISE
can recognize the received CGI commands from the IP address which
user defines. User can use the "Source Address" of CGI command in
the IF condition setting.
http://wise.icpdas.com
Figure 9-29：CGI Command
Setting" page is necessary, you have to add the parameters
Setting page (2)
(Receiving)
175
Advertisement
Table of Contents
