Remote Modbus Rtu Module Setting; Figure 6-21：Remote Modbus Rtu Module Setting Page - ICP DAS USA WISE-2841M Series User Manual

ICP DAS WISE User Manual
Please note: To set up the Power On value of the AO channels on
I-7000/DL DCON modules, please use DCON Utility to set the value.

6.4 Remote Modbus RTU Module Setting

WISE allows connections to ICP DAS M-7000/tM/DL/LC/IR/iSN modules
and general Modbus RTU Modules. The I/O Module Setting page allows
users to add Modbus RTU Module that are connected to the WISE to the list.
After the module is added, it allows to set up the configuration of the I/O
module. The setting page is shown as below:
The following section will give more information how to add and complete
settings of Modbus RTU modules. After all settings are completed, click
"Save" button to save the changes.
Please note:
1. The COM3 (RS-485) and COM4 (RS-485) interfaces on WISE allows
connections to I-7000/DL DCON modules or Modbus RTU modules.
2. A single COM Port interface (COM3 or COM4) allows connections to
at most 16 devices (I-7000/DL DCON modules or Modbus RTU
modules).
6.4.1 Scan to Add ICP DAS Modules
The user could use the Scan function to add ICP DAS M-7000
/tM/DL/LC/iSN modules to the WISE, the steps are as below:
Please Note: The ICP DAS IR modules does not support the scan
function, please add it manually.)
i. Click on
connected to the WISE.
http://wise.icpdas.com
Figure 6-21：Remote Modbus RTU Module Setting page
button to scan the ICP DAS modules that are
71