Figure 10-35：Do Action Setting Page; Figure 10-36：Ao Action Setting Page - ICP DAS USA WISE-2841M Series User Manual

ICP DAS WISE User Manual
Follow the steps below:
i Specify the module and the channel from the dropdown list of
ii Specify the output value of DO Channel from the dropdown list
iii Specify the "Execution Frequency" to be "One Time" or
iv Click "OK" button to confirm the settings and return to the Rule
10.2.1.3
You can execute an action in AO channel of ICP DAS I/O Module in
THEN/ELSE Action statement; the editing page for AO Action is
shown as follow:
http://wise.icpdas.com
Figure 10-35：DO action setting page
the "Module & Channel" section.
of the "Status" field. The output value can be "OFF", "ON" or
"Pulse Output" (Pulse Output applies to XV-Board
M-7088 belongs to PWM (Pulse width modulation) modules,
the DO channel Action will be "Start PWM" or "Stop
"Repeat". Please refer to
for detail.
settings page.
AO
Figure 10-36：AO action setting page
"10.2 THEN/ELSE Action
only). For
PWM".
Setting"
224