Figure 10-6：Do Counter Condition Setting Page - ICP DAS USA WISE-2841M Series User Manual

ICP DAS WISE User Manual
ii Define the evaluation criteria of the status in IF statement to be
iii Click "OK" button to confirm the settings and return to the Rule
10.1.1.4
DO counter values from remote ICP DAS WISE-71xx series modules
can be used as evaluation criteria for IF condition statement; the
editing page for DO Counter Condition Setting is shown as follow:
Follow the steps below:
i Specify the module and the channel from the dropdown list of
ii Set up the expression statement for this counter value. Select an
iii Specify the evaluation value. If this DO counter value match the
iv Click "OK" button to confirm the settings and return to the Rule
http://wise.icpdas.com
its value in the IF condition statements.
"OFF", "ON", "ON to OFF", "OFF to ON" or "Change". Once
the DO channel value matches the evaluation criteria, the result
of this condition evaluation will be "true".
statement involves state transitions: "ON to OFF", "OFF to
ON" and "Change", the action will be executed only once and
only at the moment when the state transition occurs.
settings page.
DO Counter
Figure 10-6：DO Counter condition setting page
the "Module & Channel" section that you are going to include
its value in the IF condition statements.
operator from "=", ">", "<", ">=", "<=" or "Change".
evaluation criteria, the result of this condition evaluation will be
"true". WISE provides 12 values options; you can compare
them with the DO counter value for condition evaluation.
"10.1.1.2 DI
Please refer to
the statement involves state transitions: "Change", user doesn‟t
need to set up the evaluation value. The action will be executed
only at the moment when the state transition occurs.
settings page.
Please note: If the
Counter" for detail. Please note: If
203