Figure 6-25：The Icp Das Module List After Scan Operation; Figure 6-26：Select The Actual Icp Das Modules - ICP DAS USA WISE-2841M Series User Manual

ICP DAS WISE User Manual
6.4.2 Add ICP DAS module or Modbus RTU Module manually
In addition to perform Scan operation to automatically add
M-7000/tM/DL/LC/iSN modules to the list, the user could also add the
ICP DAS M-7000/tM/DL/LC/IR/iSN modules or Modbus RTU
modules manually one by one, the steps are as below:
i. No: The number will be the order that the I/O channel data of the
Modbus RTU module being stored in the WISE Modbus Table. The
range is 1~16.
ii. Address: The address will be the Modbus address of this Modbus
RTU module, please make sure the address is the same as the
settings of the module, if the setting is not accurate, the connection
for WISE to the Modbus RTU module will be failed.
http://wise.icpdas.com
Figure 6-25：The ICP DAS module List after Scan operation
Figure 6-26：Select the actual ICP DAS modules
73