Table of Contents
Advertisement
ICP DAS WISE User Manual
iv When you complete the setting of Interface, Module and Channel,
please click the "Insert" button to add the channel of the I/O module
into the I/O Data Table.
v If you want to change the position of the I/O channel in the I/O Data
Table, please left-click the I/O channel by mouse, and drag it up or
down to arrange the new position of the I/O channel. When the I/O
channel arrive the right position, release the mouse left-button to let the
I/O channel be at the new location.
vi If you want to remove one I/O channel of the I/O Data Table, please
click the I/O channel by mouse, then click the "Remove" button which
is located at the right-lower corner of the I/O Data Table to remove the
I/O channel.
vii If you want to remove all I/O channel of the I/O Data Table, please
directly click the "Remove All Setting" button which is located at the
left-lower corner of the I/O Data Table to remove all I/O channels.
viii After you finish the I/O Data Table settings, click "Save" button to save
the settings.
9.8.2 Active Sending of I/O Data Table
The settings steps are as below:
i Click on the "Sending Setting" tab at the right-upper corner of the
Active I/O Sending setting page.
http://wise.icpdas.com
Figure 9-43：I/O Data Table Setting page (2)
186
Advertisement
Table of Contents
