Otto Bock Meridium 1B1-2 Series Instructions For Use Manual page 59

7.2.5.3 Mounting the Protector connecting plate
7.2.5.4 Mounting the connecting plate for the cosmetic foam cover
8 Cockpit app
The cockpit app enables switching from basic mode into the pre-configured MyModes. In
addition, information about the product (step counter, battery charge level, etc.) can be
called up.
The behaviour of the product can be changed to a certain extent on a day-to-day basis
using the app (e.g. while becoming accustomed to the product). The adjustment software
can be used to trace the change at the patient's next appointment.
Information on the Cockpit app
• The Cockpit app can be downloaded free of charge from the respective online store. For more information,
please visit the following website: https://www.ottobock.com/cockpitapp. To download the Cockpit app, the
QR code on the supplied Bluetooth PIN card can also be read with the mobile device (requirement: QR code
reader and camera).
• The language of the Cockpit app user interface can only be changed using the adjustment software.
• Depending on the version of the Cockpit app being used, the language of the user interface in the Cockpit app
corresponds to the language of the mobile device on which the Cockpit app is being used.
• The serial number of the component to be connected has to be registered with Ottobock the first time it is con­
nected. If the registration is not accepted, use of the Cockpit app for this component will be limited.
• Bluetooth on the prosthesis must be turned on in order to use the Cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down (sole of the foot must
point up) or by connecting/disconnecting the battery charger. Bluetooth is then turned on for approx.
2 minutes. During this time, the app must be started and used to establish a connection. If required, Bluetooth
on the prosthesis can be switched on permanently afterwards (see page 70).
• Keep the mobile app up to date at all times.
• Please contact the manufacturer if you suspect cybersecurity problems.
8.1 Initial connection between cockpit app and prosthesis
The following points need to be observed before establishing the connection:
• Bluetooth of the component must be switched on (see page 70).
1B1-2=* Meridium
The Protective Cover connecting plate acts as the connection between the
prosthetic foot and the Protective Cover.
1) Apply adhesive to the cover cap in 4 places (adhesive areas about 15 mm
long).
2) Fit the Protective Cover connecting plate to the cover cap which has
already been mounted.
3) Fasten the clips of the foot cuff to the connecting plate of the Protective
Cover.
INFORMATION: Please note the 647G1113/647G942 instructions for
use.
The connecting plate for the cosmetic foam cover acts as the connection
between the prosthetic foot and the cosmetic foam cover.
1) Fit the connecting plate for the cosmetic foam cover to the cover cap which
has already been mounted.
2) Trim the cosmetic foam cover to fit the connecting plate for the cosmetic
foam cover.
3) Apply a layer of 636N9 contact adhesive to the contact surfaces of the cos­
metic foam cover.
4) Place the cosmetic foam cover on the connecting plate for the cosmetic
foam cover.
Cockpit app
59