Otto Bock Meridium 1B1-2 Series Instructions For Use Manual page 77

Beep signal Vibration sig­
nal
1 x short 1 x short
2 x short 2 x short
3 x short 3 x short
15.2.2 Warnings/error signals
Error during use
Beep signal
–
–
–
10 x short
30 x long
–
1B1-2=* Meridium
Additional action performed
swing sideways three times to set
heel height
Weight placed on prosthetic leg
and leg kept still for 1 second to
switch mode or
feet placed on same level and
weight distributed evenly on both
feet to set heel height
Weight placed on prosthetic leg
and leg kept still for 1 second
Weight placed on prosthetic leg
and leg kept still for 1 second
Vibration signal
1 x long at interval of
approx. 5 seconds
3 x long
5 x long
10 x long
1 x long, 1 x short
repeated every 3 seconds
Continuous
Event
Switching to basic mode (mode 1) car­
ried out.
Switching to MyMode 1 (mode 2) car­
ried out.
Switching to MyMode 2 (mode 3) car­
ried out.
Event
Overheated hydraulic unit Reduce activity.
Battery charge level
under 25%
Battery charge level
under 15%
Charge level 0%
After the beep and vibra­
tion signals, the product
switches to empty battery
mode and then switches
off.
Severe error/indication
that safety mode
activated
e.g. one or more sensors
are not operational.
Total failure
Electronic control
longer possible. Safety
mode active or undeter­
mined valve state.
Undetermined product
behaviour.
Required action
Charge battery soon.
Charge battery immediately;
the product will be switched
off after the next warning sig­
nal.
Charge the battery.
Walking possible with restric­
is tions. Please note the possible
change in flexion/extension
resistance.
Attempt to reset this error by
connecting/disconnecting the
battery charger. The battery
charger must be connected for
at least 5 seconds before it is
disconnected.
If the error persists, use of the
product is prohibited. The
product must be inspected by
an authorised Ottobock Ser­
vice Centre.
Attempt to reset this error by
connecting/disconnecting the
no
battery charger.
If the error persists, use of the
product is prohibited. The
product must be inspected by
an authorised Ottobock Ser­
vice Centre.
Appendices
77