Otto Bock Meridium 1B1-2 Series Instructions For Use Manual page 67

Product
1. Basic Mode 2. Golf
1
2
3
100%
1. Basic Mode
9.3.2 Switching MyModes using motion patterns
Information on switching
• Switching and the number of motion patterns must be activated in the adjustment software.
• Before further activities, always check whether the selected mode corresponds to the required motion type.
If the Volume parameter is set to "0" in the Cockpit app, there are no beep signals (see page 68).
•
Switching process
1) Hold the prosthetic leg under the body.
2) Using the heel of the prosthetic foot, knock on a solid obstacle behind you (e.g. a wall) according to the num­
ber of the configured MyMode (MyMode 1 = three times, MyMode 2 = four times, MyMode 3 = five times). You
can also knock against the tip of the shoe on the contralateral leg.
→ A beep and vibration signal will occur to confirm that the movement pattern has been recognised.
INFORMATION: If this beep and vibration signal is not emitted, the knocking was not recognised.
3) Lean the prosthetic foot slightly to the back and place weight on the forefoot.
INFORMATION: If the prosthetic foot is strongly dorsiflexed, weight can be placed on the heel.
→ A confirmation signal will sound to indicate that the foot successfully switched to the corresponding mode
(two times = MyMode 1, three times = MyMode 2, four times = MyMode 3).
INFORMATION: If this confirmation signal does not occur, weight was not placed on the prosthetic
foot correctly or not for enough time. Repeat the process for correct switching.
4) Remove the load from the prosthetic leg.
→ The mode has been changed.
9.3.3 Switching on ankle lock
Information on switching
• The ankle lock must be activated as MyMode "Ankle lock" and the number of motion patterns used to switch it
on must be activated in the adjustment software.
• Before further activities, always check whether the selected mode corresponds to the required motion type.
If the Volume parameter is set to "0" in the Cockpit app, there are no beep signals (see page 68).
•
Switching process
1) Hold the prosthetic leg under the body.
2) Using the heel of the prosthetic foot, knock on a solid obstacle behind you (e.g. a wall) according to the num­
ber of the configured MyMode (MyMode 1 = 3 times, MyMode 2 = 4 times, MyMode 3 = 5 times). It is also pos­
sible to knock against the tip of the shoe of the contralateral leg.
→ A beep and vibration signal will occur to confirm that the movement pattern has been recognised.
3) Lean the prosthetic foot slightly to the back and place weight on the forefoot.
INFORMATION: If the prosthetic foot is strongly dorsiflexed, weight can be placed on the heel.
1B1-2=* Meridium
1) Tap the symbol of the MyMode (1) you want in the main menu of the
app.
→ A security question for changing the MyMode appears.
change
2) If you want to change the mode, tap the "OK" button.
→ A beep signal sounds to confirm the switch.
3) After switching, a symbol (2) is displayed to identify the active mode.
→ The current mode is also indicated by the name on the lower edge
of the screen (3).
Use
67