Otto Bock Meridium 1B1-2 Series Instructions For Use Manual page 76

Appendices
In some jurisdictions it is not permissible to dispose of these products with unsorted household
waste. Disposal that is not in accordance with the regulations of your country may have a detri­
mental impact on health and the environment. Please observe the instructions of your national
authority pertaining to return and collection.
The product's Bluetooth wireless module can establish a connection to mobile devices with the
following operating systems: iOS (iPhone, iPad, iPod...) and Android
Declaration of conformity according to the applicable European directives
Serial number (YYYY WW NNN)
YYYY – year of manufacture
WW – week of manufacture
NNN – sequential number
Lot number (PPPP YYYY WW)
PPPP – plant
YYYY – year of manufacture
WW – week of manufacture
Article number
Medical device
Please note the instructions for use
Check
Ottobock Data Station.
15.2 Operating states/error signals
The prosthesis indicates operating states and error messages through beeps and vibration signals.
15.2.1 Signals for operating states
Battery charger connected/disconnected
Beep signal
1x short
1x short
Mode switching
INFORMATION
If the Volume parameter is set to '0' in the Cockpit app, there are no beep signals (see page 68).
Beep signal Vibration sig­
nal
1 x short 1 x short
1 x short 1 x short
76
the product settings
Vibration signal
3x short
1x before beep signal
Additional action performed
Mode switching using the Cockpit
app
Tapping with
modes or
using the corresponding
Event
Battery charger is connected or
battery charger already disconnected prior to start of char­
ging mode
Charging mode started (3 sec. after connection of battery
charger)
Battery charger disconnected after start of charging mode
Event
Mode switching is performed using the
Cockpit app
heel to switch Motion pattern recognised
adjustment software
1B1-2=* Meridium
of the