Otto Bock Meridium 1B1-2 Series Instructions For Use Manual page 69

9.4.1 Changing the prosthesis setting using the cockpit app
5
Product
MyModes
Functions
Heel Height
Settings
Status
General
Manage components
Imprint/Info
9.4.2 Overview of adjustment parameters in basic mode
The parameters in basic mode describe the dynamic behaviour of the prosthesis in a normal gait cycle. These para­
meters act as basic settings for automatically adjusting the damping behaviour to the current motion situation (e.g.
ramps, slow walking speed, etc.).
The following parameters can be modified:
Parameter
Pitch
Volume
Heel Resist.
Rollover Resist.
Stair Function
9.4.3 Overview of adjustment parameters in MyModes
The parameters in the MyModes describe the static behaviour of the prosthesis for a specific motion pattern such
as golf. Damping behaviour is not automatically controlled and adjusted in MyModes.
1B1-2=* Meridium
1) Once the component is connected and in the desired mode, tap the
symbol in the main menu.
→ The navigation menu opens.
2) Tap the "Settings" menu option.
change
→ A list appears with the parameters for the currently selected mode.
3) Change the setting of the desired parameter by tapping the "<", ">"
2. Golf
symbols.
INFORMATION: The O&P professional's setting is marked and,
after the setting has been changed, can be restored by tapping
the "Standard" button.
Adjustment soft­
ware range
1000 Hz–4000 Hz 1000 Hz–4000 Hz Pitch (frequency) of beep signal for confirma­
0–4
10–60
110–170
ON–OFF
Setting range, Meaning
app
tion tones
0–4 Volume of beep signal for confirmation tones
(e.g. when checking the charge level, switch­
ing MyModes).
The "0" setting deactivates the audible feed­
back signals. However, warning signals are
still generated when errors occur (see
page 77).
± 20 Plantar flexion damping.
How fast the forefoot is lowered when weight
is placed on the heel.
± 10 This parameter defines how easy the rollover
is.
ON–OFF Switching on this function increases the
rollover angle when walking down stairs. In
order to do so, this function needs to be
enabled in the adjustment software.
Use
69