Otto Bock Meridium 1B1-2 Series Instructions For Use Manual page 66

Use
9.2.11 Kneeling
If the leg with the joint is tilted backwards, plantar flexion damping is reduced, making it
possible for the foot to bend so the lower leg can lie flatter to the ground surface.
9.2.12 Relief function
When weight is evenly placed on the heel without movement for more than 2 seconds, the
tip of the foot lowers to reach a more natural foot position.
Possible applications include sitting with the heel in front of the knee axis, standing while
leaning against something, and standing on a downward sloping surface.
9.3 MyModes
In addition to basic mode (mode 1), MyModes can be activated and configured with the adjustment software. They
can be called up by the patient using the Cockpit app or movement patterns. Switching by using movement pat­
terns has to be activated in the adjustment software.
These modes are intended for specific motion patterns or postures (e.g. golfing, ...). Default settings for these
movement patterns and postures can be accessed and individually adapted using the adjustment software.
Settings can also be adjusted by the patient using the Cockpit app (see page 69).
9.3.1 Switching MyModes with the cockpit app
INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the Cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down (function only available in
basic mode) or by connecting/disconnecting the battery charger. Bluetooth is then turned on for approx. 2
minutes. During this time, the app must be started and used to establish a connection. If required, Bluetooth on
the prosthesis can be switched on permanently afterwards (see page 70).
INFORMATION
If the Volume parameter is set to '0' in the Cockpit app, there are no beep signals (see page 68).
Once a connection to a prosthesis has been established, the cockpit app can be used to switch between the
MyModes.
66 1B1-2=* Meridium