Otto Bock Meridium 1B1-2 Series Instructions For Use Manual page 50

Safety
NOTICE
Use of incorrect power supply unit/battery charger
Damage to product due to incorrect voltage, current or polarity.
► Use only power supply units/battery chargers approved for this product by Ottobock (see instructions for use
and catalogues).
4.5 Battery charger information
NOTICE
Penetration of dirt and humidity into the product
Lack of proper charging functionality due to malfunction.
► Ensure that neither solid particles nor liquids can penetrate into the product.
NOTICE
Mechanical stress on the power supply/battery charger
Lack of proper charging functionality due to malfunction.
► Do not subject the power supply/battery charger to mechanical vibrations or impacts.
► Check the power supply/battery charger for visible damage before each use.
NOTICE
Operating the power supply unit/charger outside of the permissible temperature range
Lack of proper charging functionality due to malfunction.
► Only use the power supply unit/charger for charging within the allowable temperature range. The section
"Technical data" contains information on the allowable temperature range (see page 74).
NOTICE
Independent changes or modifications carried out to the battery charger
Lack of proper charging functionality due to malfunction.
► Have any changes or modifications carried out only by Ottobock authorised, qualified personnel.
4.6 Information on Alignment/Adjustment
CAUTION
Use of unsuitable prosthesis components
Falling due to unexpected behaviour of the product or breakage of load-bearing components.
► Use the product only in combination with components listed in the section "Combination possibilities" (see
page 46).
CAUTION
Use of unapproved accessories
> Falling due to product malfunction as a result of reduced resistance to interference.
> Interference of other electronic devices due to increased emissions.
► Use the product only in combination with the accessories, signal converters and cables listed in the sections
"Combination possibilities" (see page 46), "Scope of delivery" (see page 54) and "Accessories" (see
page 54).
CAUTION
Incorrect alignment or assembly
Falling due to damage to the prosthesis components.
► Observe the alignment and assembly instructions.
50 1B1-2=* Meridium