Otto Bock Meridium 1B1-2 Series Instructions For Use Manual page 60

Cockpit app
• Bluetooth on the mobile device must be switched on.
• The mobile device must not be in "flight mode" (offline mode), otherwise all wireless connections are turned
off.
• The mobile device must be connected to the Internet.
• The serial number and Bluetooth PIN of the component being connected must be known. They are found on
the enclosed Bluetooth PIN card. The serial number begins with the letters "SN".
INFORMATION
If the Bluetooth PIN card with the Bluetooth PIN and serial number of the component is lost, the Bluetooth PIN
can be determined using the adjustment software.
8.1.1 Starting the cockpit app for the first time
1) Tap the symbol of the Cockpit app (
→ The end user license agreement (EULA) is displayed.
2) Accept the end user license agreement (EULA) by tapping the Accept button. If the end user license agree­
ment (EULA) is not accepted, the Cockpit app cannot be used.
→ The welcome screen appears.
3) Hold the prosthesis with the sole of the foot facing up, or connect and then disconnect the battery charger, in
order to activate recognition (visibility) of the Bluetooth connection for 2 minutes.
4) Tap the Add component button.
→ The Connection Wizard opens and guides you through the process of establishing a connection.
5) Follow the subsequent instructions on the screen.
6) After the Bluetooth PIN is entered, a connection to the component is established.
→ While the connection is being established, 3 beep signals sound and the
The symbol is displayed when the connection has been established.
→ Once the connection has been established, the data are read from the component. This process may take up to
a minute.
Then the main menu appears with the name of the connected component.
INFORMATION
After the initial connection to the component has been established successfully, the app will connect automatically
each time it is started. No further steps are required.
8.2 Control elements for cockpit app
1
Product
2
1. Basic Mode 2. Golf
4
5
6
100% 1. Basic Mode
60
).
1. Access the navigation menu (see page 61)
2. Product
The component name can only be changed with the adjustment soft­
change
ware.
3
3. If connections to more than one component have been saved, you can
switch between the saved components by tapping the change item (see
page 61).
4. MyModes configured with the adjustment software.
Switch the mode by tapping the corresponding symbol and confirming
by tapping "OK".
5. Currently selected mode
6. Charge level of the component.
Component battery fully charged
7
Component battery empty
8
Component battery charging
The current charge level is also displayed in %.
7. Display and name of the currently selected mode (e.g. 1. Basic Mode)
8. Connection to component has been established
Connection to component has been interrupted. The app is attempt­
ing to re-establish the connection automatically.
No existing connection to the component.
symbol appears.
1B1-2=* Meridium