6-3-3.Paper Misfeed Occurred At The Paper Exit Section - Minolta QMS PageWorks/Pro 1100 Service Manual

Check
Do the Paper Take-up Sensor
(PS1) lever move correctly?
6-3-3. Paper misfeed occurred at the paper exit section
Check
The paper stops when approxi-
mately 5-3/4" (or 14.5mm) of it's
leading edge comes out from the
Exit Roller.
↓ No
Is the Image Transfer Roller
deformed, worn, or dirty with
paper dust?
↓ No
Is the Fusing roller deformed,
worn, or dirty with paper dust?
↓ No
Does the Paper exit roller rotate?
↓ Yes
Does the Paper Exit Sensor
(PS3) lever move correctly?
Remedy
→ No
Correct the Sensor lever move-
ment.
→ Yes Replace PS1.
P .64
Replace the Controller Board.
P .53
Remedy
→ Yes Replace PS1.
P .64
Replace the Controller Board.
P .53
→ Yes Replace the Image Transfer
Roller.
P .51
→ Yes Replace the Fusing unit.
P .58
→ No
Replace the Top Cover Assy.
P .56
→ No
Correct the Sensor lever move-
ment.
→ Yes Replace PS3.
P .62
Replace the Controller Board.
P .53
75