MacDon M Series Unloading And Assembly Instructions page 269

7. Press right (C) arrow to select YES. Press
SELECT (D).
• The most recent error code will be displayed.
8. Press and left (B) or right (C) arrow to cycle through the
last ten recorded errors until EXIT WINDRWR CODES
is displayed.
9. Press right (C) arrow to select YES. Press
SELECT (D).
10. Press PROGRAM
Mode or press SELECT (D) to proceed to next
DIAGNOSTIC MODE.
11. Press right (C) arrow to select YES. Press
SELECT (D).
• The most recent error code will be displayed.
12. Press and left (B) or right (C) arrow to cycle through
the last ten recorded windrower error codes until EXIT
WINDROWER CODES is displayed.
13. Press right (C) arrow to select YES. Press
SELECT (D).
• VIEW ENGINE CODES is displayed on the
upper line.
• NO/YES is displayed on the lower line.
147962
CAB DISPLAY MODULE (CDM)
(A) to exit Programming
Figure 4.236: M105 Windrower Codes
Figure 4.237: M155 Windrower Codes
Figure 4.238: M205 Windrower Codes
255
Revision A