MacDon M Series Unloading And Assembly Instructions page 271

1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
3. Press SELECT (C) until DIAGNOSTIC MODE? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
4. Press right (B) arrow to select YES. Press SELECT (C).
• VIEW ERROR CODES? is displayed on the
upper line.
147962
CAB DISPLAY MODULE (CDM)
Figure 4.241: M105 CDM Programming Buttons
Figure 4.242: M155 CDM Programming Buttons
Figure 4.243: M205 CDM Programming Buttons
257
Revision A