Testing The Draper Or Auger Drive Circuit Activate Function Using The Cab Display Module (Cdm) On An M105 - MacDon M Series Unloading And Assembly Instructions

5. Press SELECT (B) until ACTIVATE FUNCTIONS? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
6. Press right (A) arrow to select YES. Press SELECT (B).
CAUTION
Check to be sure all bystanders have cleared the area.
7. Press SELECT (C) until KNIFE DRIVE ON is displayed
on the lower line.
8. Press and hold right (B) arrow to activate knife drive.
Verify knife is functioning properly.
9. Release right (B) arrow to deactivate knife drive.
10. Press PROGRAM
Mode or press SELECT (C) to proceed to next
ACTIVATE FUNCTION.
4.8.5 Testing the Draper or Auger Drive Circuit Activate Function Using the
Cab Display Module (CDM) on an M105
NOTE:
• The header MUST be attached to windrower to perform this procedure.
• The engine MUST be running to perform this procedure.
147962
CAB DISPLAY MODULE (CDM)
(A) to exit Programming
Figure 4.305: Activate Functions
Figure 4.306: Knife Drive
284
Revision A