Activating The Draper Speed Control Lockout - MacDon M Series Unloading And Assembly Instructions

6. Press SELECT (D) until HEADER FLOAT is displayed
on the upper line.
• ENABLED/LOCKED is displayed on the lower line.
7. Press left arrow (B) to enable HEADER FLOAT control
switch, or press right arrow (C) to lock HEADER FLOAT
control switch.
8. Press PROGRAM (A) to exit Programming Mode or
press SELECT (D) to proceed to next WINDROWER
SETUP action.

4.5.4 Activating the Draper Speed Control Lockout

NOTE:
• This procedure is for draper headers only.
• The header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
147962
CAB DISPLAY MODULE (CDM)
Figure 4.174: M155 Header Float Control Lock
Figure 4.175: M205 Header Float Control Lock
230
Revision A