Testing The Reel Drive Circuit Activate Function Using The Cab Display Module (Cdm) - MacDon M Series Unloading And Assembly Instructions

CAUTION
Check to be sure all bystanders have cleared the area.
7. Press SELECT (B) until DRAPER DRV SPD XXXX is
displayed on the upper line.
IMPORTANT:
Do NOT over-speed the drapers.
8. Press and hold HAZARD (C) button.
• Press left (B) arrow to decrease draper speed.
• Press right (D) arrow to increase draper speed.
Verify the draper drive is functioning properly.
9. Release the HAZARD (C) button.
will stop.
PROGRAM
10. Press
Mode or press SELECT (E) to proceed to next
ACTIVATE FUNCTION.
4.8.11 Testing the Reel Drive Circuit Activate Function Using the Cab
Display Module (CDM)
IMPORTANT:
Do not over-speed a drive. Over-speeding can lead to vibration, belt failures, or other over-speeding related
problems.
NOTE:
• The header MUST be attached to windrower to follow this procedure.
• This procedure does not apply to rotary disc headers.
• The engine MUST be running to perform this procedure.
147962
CAB DISPLAY MODULE (CDM)
The drapers
(A) to exit Programming
Figure 4.356: M155 Draper Drive
Figure 4.357: M205 Draper Drive
305
Revision A