MacDon M Series Unloading And Assembly Instructions page 196

6. Press and hold FLOAT + button (A) on the CDM.
• CALIBRATING
upper line.
• FLOAT ( + ) HOLD is displayed on the lower line.
NOTE:
The word HOLD will flash during calibration.
FLOAT (+) DONE will display on the lower line
once calibration is complete.
7. Release the FLOAT + button (A).
• CALIBRATING
upper line.
• FLOAT ( - ) HOLD is displayed on the lower line.
147962
CAB DISPLAY MODULE (CDM)
FLOAT is displayed
FLOAT is displayed
on the
on the
Figure 4.68: M155 Positive Header Float
Figure 4.69: M205 Positive Header Float
182
Revision A