MacDon M Series Unloading And Assembly Instructions page 119

1. Remove hairpin (A) from pins (B), and remove pins
from both header legs.
CAUTION
Check to be sure all bystanders have cleared the area.
2. Start the engine and activate the HEADER DOWN
button (A) on the ground speed lever (GSL) to fully
retract header lift cylinders.
3. Relocate pin (A) in frame linkage as required to
raise the center-link (B) until the hook is above the
attachment pin on the header.
IMPORTANT:
If the center-link is too low, it may contact the
header as the windrower approaches the header
for hookup.
147962
ASSEMBLING THE WINDROWER
Figure 3.175: Header Leg
Figure 3.176: Ground Speed Lever
Figure 3.177: Hydraulic Center-Link without
Self-Alignment Kit
105
Revision A