MacDon M Series Unloading And Assembly Instructions page 58

2. Position hose (MD #111323 [orange tie]) (D) and
hose (MD #111324 [white tie]) (E) with tee under the
center of the clip as shown, and loosely install two
bolts and nuts.
NOTE:
Part numbers are marked on the hoses.
3. Position remaining hoses under clip as shown and
tighten bolts.
4. Locate two hoses (MD #111327 [green ties]) (A) in
frame opening and existing tee fitting (green tie) on the
hose from the valve block.
5. Remove caps from the hoses (A) only.
6. Remove one cap from tee fitting, and quickly attach
hose (A) to minimize oil spillage.
7. Remove second cap from tee fitting, and quickly
connect other hose (A).
8. Tighten fittings.
9. Position hoses into frame.
10. Locate two hoses (white ties) inside frame and
hose (MD #111324)
(white tie) (A).
11. Remove caps, make connections, and tighten fittings.
12. Position hoses into frame.
147962
ASSEMBLING THE WINDROWER
with existing tee fitting
Figure 3.37: Hose Routing (View Looking
Forward)
A - Hose Clip
C - Blue Tie (MD #111323)
E - White Tie (MD #111324)
G - White Tie (MD #111328)
Figure 3.38: Hose Routing
Figure 3.39: Hose Routing
44
B - Yellow Tie (MD #111557)
D - Orange Tie (MD #111323)
F - Green Tie (MD #111327)
Revision A