MacDon M Series Unloading And Assembly Instructions page 266

6. Press left (B) or right (C) arrow to cycle between control
switch lock outs. The displayed control switches are
as follows:
• HEADER TILT
• HEADER FLOAT
• REEL FORE/AFT
• DRAPER SPEED
• AUGER SPEED
• KNIFE SPEED
• DISK SPEED
• REEL SPEED
NOTE:
Not all control locks apply to every header.
7. Press SELECT.
• EXIT VIEW LOCKOUTS? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
8. Press right to select YES.
9. Press PROGRAM to exit Programming Mode or
press SELECT to proceed to next WINDROWER
SETUP action.
147962
CAB DISPLAY MODULE (CDM)
Figure 4.227: M105 Control Locks
Figure 4.228: M155 Control Locks
Figure 4.229: M205 Control Locks
252
Revision A