Predelivery Checklist - MacDon M Series Unloading And Assembly Instructions

Predelivery Checklist

Perform these checks and adjustments prior to delivery to your Customer. The completed checklist should be
retained by either the Operator or the Dealer.
CAUTION
Carefully follow the instructions given. Be alert for safety related messages that bring your attention to
hazards and unsafe practices.
Windrower Serial Number:
Table 1 M-Series Self-Propelled Windrower Predelivery Checklist – Export
 Item
Check for shipping damage or missing parts. Be sure all
shipping dunnage is removed.
Check for loose hardware. Tighten to required torque.
Check tire air pressures and adjust as required.
Check final drive hub lubricant level.
Check engine coolant level and strength at reserve tank.
Check air cleaner and clamps.
Check hydraulic oil level and check for leaks along lines.
Check fuel separator for water and foreign material. Drain
and clean as necessary. Add fuel.
Check gearbox lubricant level (M155 and M205).
Check tension of air conditioning compressor belt.
Check that machine is completely lubricated.
Check neutral interlock system.
Check engine oil pressure indicator light at cab display
module (CDM).
Start engine and run to operating temperature.
Check CDM for operation.
Check Operator's Presence System.
Check alternator charge rate on CDM.
Check fuel gauge/indicator for operation.
Check that air conditioning is functioning properly.
147962
Engine Serial Number:
Reference
6 Reference, page 357
5.3.1 Checking Tire Pressures, page 322
5.2 Checking and Adding Wheel Drive Lubricant
Level, page 321
5.7 Checking Engine Coolant, page 329
5.4 Checking Engine Air Intake, page 324
5.5 Checking Hydraulic Oil, page 327
5.6 Checking Fuel Separator, page 328
5.8 Checking Gearbox Lubricant Level on an
M155/M205, page 330
5.9 Checking Air Conditioning (A/C) Compressor
Belts, page 331
3.22 Lubricating the Windrower, page 150
5.10 Checking Safety System, page 332
5.11.1 Checking Engine Warning Lights, page
336
5.11.3 Checking Windrower Startup, page 337
5.11.5 Checking Gauges and Cab Display
Module (CDM) Display, page 338
5.11.8 Checking Operator's Presence System,
page 341
5.11.7 Checking Electrical System, page 340
5.11.5 Checking Gauges and Cab Display
Module (CDM) Display, page 338
5.11.12 Checking Air Conditioning (A/C) and
Heater, page 350
379
—
Revision A