MacDon M Series Unloading And Assembly Instructions page 100

Table 3.1 Engine Start Troubleshooting
Problem
Controls not in NEUTRAL
Operator's station not locked
Neutral interlock misadjusted
No fuel to engine
Old fuel in tank
Water, dirt, or air in fuel system
Improper type of fuel
Crankcase oil too heavy
Low battery output
Poor battery connection
Faulty starter
Wiring shorted, circuit breaker open
Faulty injectors
147962
ASSEMBLING THE WINDROWER
Solution
• Move GSL to NEUTRAL
• Move steering wheel to locked position
• Disengage header clutch
• Adjust position of operator's station
• Ensure lock is engaged
• Refer to the windrower technical manual
• Fill empty fuel tank
• Replace clogged filter
• Ensure fuel shut off valve is in open position
• Drain tank
• Refill with fresh fuel
• Drain, flush, fill, and prime system
• Use proper fuel for operating conditions
• Use recommended oil
• Test the battery
• Check battery electrolyte level
• Clean and tighten loose connections
• Refer to the windrower technical manual
• Check continuity of wiring and breaker (manually reset)
• Refer to the windrower technical manual
86
Revision A