MacDon M Series Unloading And Assembly Instructions page 116

Self-propelled windrower

Hide thumbs Also See for M Series:

Table of Contents

11. Engage safety props on both lift cylinders as follows:

a. Stop engine and remove key from ignition.

b. Pull lever (A) and rotate towards the header

to release and lower safety prop (B) onto the

lift cylinder.

c. Repeat for opposite lift cylinder.

12. Install pin (B) through the header leg (engaging

U-bracket in lift linkage) on both sides and secure with

hairpin (A).

13. Raise header stand (D) to storage position by pulling

spring pin (C) and lifting stand into uppermost position.

Release spring pin.

ASSEMBLING THE WINDROWER

Figure 3.168: Safety Prop

Figure 3.169: Header Leg

Troubleshooting