MacDon M Series Unloading And Assembly Instructions page 213

NOTE:
The header MUST be attached to the windrower to perform this procedure.
1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
3. Press right (B) arrow to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed.
• SELECT HEADER TYPE? is displayed.
147962
CAB DISPLAY MODULE (CDM)
Figure 4.106: M105 CDM Programming Buttons
Figure 4.107: M155 CDM Programming Buttons
Figure 4.108: M205 CDM Programming Buttons
199
Revision A