Switching The Installed Header Sensors On Or Off - MacDon M Series Unloading And Assembly Instructions
Self-propelled windrower
Hide thumbs
Also See for M Series:
- Unloading and assembly instructions (95 pages) ,
- Assembly instructions manual (91 pages) ,
- Assembly instructions manual (117 pages)
Table of Contents
Advertisement
14. Press right (C) arrow to select YES. Press
SELECT (D).
15. Press left (B) or right (C) arrow to cycle through the last
ten recorded engine error codes until EXIT ENGINE
CODES is displayed.
16. Press right (C) arrow to select YES. Press
SELECT (D).
17. Press
PROGRAM
Mode or press SELECT (D) to proceed to next
DIAGNOSTIC MODE.
4.7.2 Switching the Installed Header Sensors ON or OFF
You can selectively enable or disable header sensors in the event of a malfunction or as part of a
troubleshooting routine.
NOTE:
• The header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
• Displaying knife, reel, and center-link readings require installation of the optional Expansion Module
(MD #B4666).
For more information, refer to the windrower operator's manual or the windrower
technical manual.
• Disabled sensors flash the word SENSOR on CDM during regular operation.
147962
CAB DISPLAY MODULE (CDM)
(A)
to
exit
Programming
Figure 4.239: M155 Engine Codes
Figure 4.240: M205 Engine Codes
256
Revision A
Advertisement
Table of Contents
Troubleshooting
