MacDon M Series Unloading And Assembly Instructions page 9

Summary of Change
Added new cross-reference and section for fluids,
lubricants, and system capacities.
Revised Note regarding cab display module and
windrower control module software to clarify software
version compatibility with different M-Series windrower
models.
Revised Notes specific to the M105 for clarity.
Corrected references in Steps 7 and 8 from callouts C
and D to callouts A and B.
Replaced arrows showing serial number locations with
callouts.
Updated illustration to show new gearbox cover.
Corrected broken links to Table
Setting, page 352.
Replaced M105 Operator Console illustration to show
header drive switch.
Added new section for tapered pipe fittings.
Added new terms and acronyms.
Added new section for fuel specifications.
147962
5.5 Knife Speed
vii
Location
• 3.22 Lubricating the Windrower, page 150
• 5.2 Checking and Adding Wheel Drive Lubricant
Level, page 321
• 6.4 Lubricants, Fluids, and System Capacities, page
374
4.2 Cab Display Options, page 156
• 4.4.9 Setting the Header Index Mode, page 196
• 4.7.3 Displaying Header Sensor Input Signals, page
260
• 4.8.3 Testing the Header Tilt Activate Function Using
the Cab Display Module (CDM), page 278
• 4.8.7 Testing the Reel Fore-Aft Activate Function
Using the Cab Display Module (CDM), page 288
5.1 Recording Serial Numbers, page 319
5.8 Checking Gearbox Lubricant Level on an
M155/M205, page 330
• Setting Knife Speed, page 352
• Adjusting Knife Speed, page 353
5.11.8 Checking Operator's Presence System, page
341
6.1.8 Tapered Pipe Thread Fittings, page 369
6.3 Definitions, page 371
6.5 Fuel Specifications, page 378
Revision A