MacDon M Series Unloading And Assembly Instructions page 71

Self-propelled windrower

Hide thumbs Also See for M Series:

Table of Contents

25. Bundle traction drive hoses and secure with two plastic

cable ties (A) at 200 mm (7-3/4 in.) intervals from the

frame opening.

26. Bundle smaller hoses and secure with two plastic

cable ties (B) at 150 mm (6 in.) intervals from the

frame opening.

27. Position hose bundle (A) from the valve blocks on the

left-hand side of the frame onto the tire.

28. Note routing of electrical harness.

The electrical harness must be routed on the

topside of the hose bundle and on the outside

of the hose support to prevent chaﬁng of the

electrical wires when the windrower is operating

with a header.

ASSEMBLING THE WINDROWER

Figure 3.71: Hose Routing

Figure 3.72: Hose Routing

Troubleshooting