MacDon M Series Unloading And Assembly Instructions page 139

12. Install clevis pin (A) through boot and foot and secure
with hairpin. Repeat for opposite boot.
IMPORTANT:
Ensure clevis pin (A) is fully inserted and hairpin
is installed behind bracket.
13. Remove lynch pin from clevis pin (A) in stand (B).
14. Hold stand (B) and remove pin (A).
15. Move stand (B) to storage position by inverting and
relocating onto bracket as shown.
pin (A) and secure with lynch pin.
16. Remove clevis pin from storage position (B) in linkage
and insert into hole (A) to engage float springs. Secure
with hairpin.
147962
ASSEMBLING THE WINDROWER
Figure 3.228: Header Boot
Reinsert clevis
Figure 3.229: Header Stand
Figure 3.230: Header Float Linkage
125
Revision A