MacDon M Series Unloading And Assembly Instructions page 214

4. Press SELECT (D) until RETURN TO CUT MODE? is
displayed on the upper line.
• HEIGHT & TILT or HEIGHT ONLY will be displayed
on the lower line.
NOTE:
RETURN TO CUT MODE will display HEIGHT ONLY
unless the optional Expansion Module (MD #B4666)
is installed. For more information, refer to the
windrower operator's manual or the windrower
technical manual.
5. Press left (B) or right (C) arrows to select return to cut
mode. Press SELECT (D).
6. Press PROGRAM (A) to exit Programming Mode or
press SELECT (D) to proceed to next WINDROWER
SETUP action.
147962
CAB DISPLAY MODULE (CDM)
Figure 4.109: M105 Return to Cut Mode
Figure 4.110: M155 Return to Cut Mode
Figure 4.111: M205 Return to Cut Mode
200
Revision A