1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
3. Press right (B) arrow to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed.
• SELECT HEADER TYPE? is displayed.
147962
CAB DISPLAY MODULE (CDM)
Figure 4.86: M105 CDM Programming Buttons
Figure 4.87: M155 CDM Programming Buttons
Figure 4.88: M205 CDM Programming Buttons
191
Revision A