MacDon M Series Unloading And Assembly Instructions page 256

Self-propelled windrower

Hide thumbs Also See for M Series:

Table of Contents

1. Turn ignition key to RUN, or start the engine.

2. Press PROGRAM (A) and SELECT (C) on cab display

module (CDM) to enter Programming Mode.

• WINDROWER SETUP? is displayed on the

• NO/YES is displayed on the lower line.

3. Press right (B) arrow to select YES. Press SELECT (C).

• SET KNIFE SPEED? is displayed on the upper line.

• SELECT HEADER TYPE? is displayed on the

CAB DISPLAY MODULE (CDM)

Figure 4.203: M105 CDM Programming Buttons

Figure 4.204: M155 CDM Programming Buttons

Figure 4.205: M205 CDM Programming Buttons

Troubleshooting