MacDon M Series Unloading And Assembly Instructions page 123

CAUTION
Check to be sure all bystanders have cleared the area.
18. Start the engine and activate the HEADER DOWN
switch (A) on the GSL to fully lower the header.
19. Stop engine and remove key from ignition.
20. Connect header drive hoses (A) and electrical
harness (B) to header. Refer to the draper header
operator's manual.
21. Connect reel hydraulics (A) at right cab-forward
side of windrower.
operator's manual.
22. Start engine and raise and lower the header and the
reel a few times to remove trapped air.
147962
ASSEMBLING THE WINDROWER
Refer to the draper header
Figure 3.186: Ground Speed Lever
Figure 3.187: Header Drive Hoses and Harness
Figure 3.188: Reel Hydraulics
109
Revision A