MacDon M Series Unloading And Assembly Instructions page 226

1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (C) on CDM to
enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
3. Press right (B) arrow to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed on the upper line.
147962
CAB DISPLAY MODULE (CDM)
Figure 4.134: M155 CDM Programming Buttons
Figure 4.135: M205 CDM Programming Buttons
212
Revision A