MacDon M Series Unloading And Assembly Instructions page 129

M155 Self-Propelled Windrower
The M155 Self-Propelled Windrower is factory-equipped to
run an A-Series Auger Header.
Windrowers equipped with A-Series hydraulics have four
header-drive hoses on the left-hand side.
The attachment procedure varies depending on the type
of center-link installed on the windrower.
following instructions based on the type of center-link
installed on your windrower:
• Attaching an A-Series Header: Hydraulic Center-Link
with Optional Self-Alignment, page 116
• Attaching an A-Series Header: Hydraulic Center-Link
without Self-Alignment, page 121
• Attaching an A-Series Header: Mechanical Center-Link,
page 127
M205 Self-Propelled Windrower
To operate an A-Series Auger Header, the M205
Self-Propelled Windrower must be equipped with an Auger
Drive Basic kit and a Completion kit.
Windrowers equipped with A-Series hydraulics have four
header drive hoses on the left-hand side.
If necessary, obtain the following kits and install them in
accordance with the instructions supplied with the kits:
Kit Description
Base Draper/Auger Drive Kit
Draper Conditioner/Auger Header
Reverser Completion Kit
Hydraulic Coupler Kit
Refer to the following procedures according to the
center-link installed on your windrower:
• Attaching an A-Series Header: Hydraulic Center-Link
with Optional Self-Alignment, page 116
• Attaching an A-Series Header: Hydraulic Center-Link
without Self-Alignment, page 121
147962
ASSEMBLING THE WINDROWER
Refer to the
Kit Number
MD #B5491
MD #B5492
MD #B5497
115
Figure 3.202: M155 and A40-D Auger Header
Figure 3.203: M205 Auger Header Drive
Hydraulics
Revision A