MacDon M Series Unloading And Assembly Instructions page 69

16. Loosen bolts (A) and move valve block (B) to improve
access through the hole in the frame in order to insert
wrenches and tighten fittings.
17. Retrieve matching hose and make connection on valve
block. Tighten fitting.
18. Reposition valve block and retighten bolts.
19. Connect drive hoses to pump as follows:
a. Remove caps and attach hose with yellow tie (A)
and hose with green tie (B) to matching fittings on
top of pump. Tighten fittings.
b. Remove caps and attach hose with red tie (A)
and hose with white tie (B) to matching fittings on
bottom of pump. Tighten fittings.
147962
ASSEMBLING THE WINDROWER
Figure 3.66: Valve Block
Figure 3.67: Top of Pump
Figure 3.68: Bottom of Pump
55
Revision A