MacDon M Series Unloading And Assembly Instructions page 84

6. Tighten both clamps (A) just enough to permit the
stack (B) to move.
7. Close the hood slowly so the stack (A) enters the
hole (B) in the hood. Adjust the position of the stack
as required to clear the hole in the hood.
8. Raise the hood.
9. Tighten clamps (A).
10. Reposition shroud (B) and tighten wing nut.
147962
ASSEMBLING THE WINDROWER
Figure 3.103: Exhaust Stack under Hood
Figure 3.104: Exhaust Stack Installed
Figure 3.105: Exhaust Stack under Hood
70
Revision A