Write Protection And Simulation Mode; Standard Automatic Adjustment; Standard Automatic Adjustment For Linear Actuators; Standard Automatic Adjustment For Rotary Actuators - ABB TZIDC-210 Operating Instructions Manual

52 TZIDC-210, TZIDC-220 DIGITAL POSITIONER | OI/TZIDC-210/TZIDC-220-EN REV. G
... 9 Commissioning

Write protection and simulation mode

There are two jumpers on the mainboard that can be used to
activate or block simulation mode and write access.
Set the jumpers as shown below:
Figure 23: Jumpers
Jumper / position Function
1 A
Simulation blocked*
B
Simulation enabled
2 A
Write access disabled
B
Write access released*
* Default setting (in accordance with Fieldbus Foundation standard)

Standard automatic adjustment

Note
Standard Auto Adjust does not always result in optimum control
conditions.

Standard automatic adjustment for linear actuators*

A B
1. MODE Press and hold until ADJ_LIN is displayed.
1
2. MODE Press and hold until the countdown ends.
3. Release MODE; this starts Autoadjust.
2

Standard automatic adjustment for rotary actuators*

1. ENTER Press and hold until ADJ_ROT is displayed.
2. ENTER Press and hold until the countdown ends.
3. Release ENTER; this starts Autoadjust.
If Autoadjust is successful, the parameters will be stored
automatically and the positioner will revert to operating mode
1.1.
If an error occurs during Autoadjust, the process will be
terminated with an error message.
Perform the following steps if an error occurs:
1. Press and hold down operating button  or  for
approximately three seconds.
The unit will switch to the operating level, mode 1.3 (manual
adjustment within the measuring range).
2. Check mechanical mounting in accordance with Mechanical
mounting on page 38 and repeat the standard automatic
adjustment.
* The zero position is determined automatically and saved during standard
automatic adjustment, counter-clockwise (CTCLOCKW) for linear actuators
and clockwise (CLOCKW) for rotary actuators.