Input References - ABB ACS880 Firmware Manual

92 Parameters
No. Name/Value
01.18 Inverter GWh
counter
0...65535 GWh
01.19 Inverter MWh
counter
0...999 MWh
01.20 Inverter kWh
counter
0...999 kWh
01.24 Flux actual %
0...200%
01.29 Speed change rate
-15000 ... 15000
rpm/s
01.30 Nominal torque
scale
0.000... N·m or lb·ft Nominal torque.
01.31 Ambient
temperature
-32768 ... 32767 °C
or °F
03

03 Input references

03.01 Panel reference
-100000.00 ...
100000.00
03.05 FB A reference 1
-100000.00 ...
100000.00
03.06 FB A reference 2
-100000.00 ...
100000.00
03.07 FB B reference 1
-100000.00 ...
100000.00
Description
Amount of energy that has passed through the drive (in either
direction) in full gigawatt-hours. The minimum value is zero.
Energy in GWh.
Amount of energy that has passed through the drive (in either
direction) in full megawatt-hours. Whenever the counter rolls
over, 01.18 Inverter GWh counter
minimum value is zero.
Energy in MWh.
Amount of energy that has passed through the drive (in either
direction) in full kilowatt-hours. Whenever the counter rolls
over, 01.19 Inverter MWh counter
minimum value is zero.
Energy in kWh.
Used flux reference in percent of nominal flux of motor.
Flux reference.
Rate of speed reference change after the speed ramp
generator.
See also parameters 31.32 Emergency ramp supervision
31.33 Emergency ramp supervision
Rate of speed change.
Torque that corresponds to 100% of nominal motor torque.
The unit is selected by parameter
Note: This value is copied from parameter
nominal torque if entered. Otherwise the value is calculated
from other motor data.
Measured temperature of incoming cooling air. The unit is
selected by parameter 96.16 Unit
Cooling air temperature.
Values of references received from various sources.
All parameters in this group are read-only unless otherwise
noted.
Reference given from the control panel or PC tool.
Control panel or PC tool reference.
Reference 1 received through fieldbus adapter A.
See also chapter Fieldbus control through a fieldbus adapter
(page 375).
Reference 1 from fieldbus adapter A.
Reference 2 received through fieldbus adapter A.
Reference 2 from fieldbus adapter A.
Reference 1 received through fieldbus adapter B.
Reference 1 from fieldbus adapter B.
is incremented.The
is incremented.The
and
delay.
96.16 Unit selection
99.12 Motor
selection.
Def/FbEq16
-
1 = 1 GWh
-
1 = 1 MWh
-
10 = 1 kWh
-
1 = 1%
-
1 = 1 rpm/s
-
1 = 100 unit
-
1 = 1°
-
1 = 10
-
1 = 10
-
1 = 10
-
1 = 10