ABB ACS880 Firmware Manual page 194

194 Parameters
No. Name/Value
AI1 scaled
AI2 scaled
PID
Maximum torque 2
Other
30.23 Minimum torque 2
-1600.0 ... 0.0%
30.24 Maximum torque 2
0.0 ... 1600.0%
30.25 Maximum torque
sel
Torque limit set 1
Torque limit set 2
DI1
DI2
DI3
DI4
DI5
DI6
DIO1
DIO2
Other [bit]
30.26 Power motoring
limit
0.00 ... 600.00%
30.27 Power generating
limit
-600.00 ... 0.00%
Description
12.12 AI1 scaled value
12.22 AI2 scaled value
40.01 Process PID output actual
controller).
30.24 Maximum torque
Source selection (see Terms and abbreviations
Defines the minimum torque limit for the drive (in percent of
nominal motor torque) when
• the source selected by parameter
sel is 1, and
• 30.21 is set to Minimum torque
See diagram at 30.18 Minimum torque
Minimum torque limit 2.
Defines the maximum torque limit for the drive (in percent of
nominal motor torque) when
• the source selected by parameter
sel is 1, and
• 30.22 is set to Maximum torque
See diagram at 30.18 Minimum torque
Maximum torque limit 2.
Selects a source that switches between two different
maximum torque limits.
0 = Maximum torque limit 1 defined by
1 = Maximum torque limit selected by
See also parameter 30.18 Minimum torque
0.
1.
Digital input DI1 (10.02 DI delayed
Digital input DI2 (10.02 DI delayed
Digital input DI3 (10.02 DI delayed
Digital input DI4 (10.02 DI delayed
Digital input DI5 (10.02 DI delayed
Digital input DI6 (10.02 DI delayed
Digital input/output DIO1
Digital input/output DIO2
Source selection (see Terms and abbreviations
Defines the maximum allowed power fed by the inverter to the
motor in percent of nominal motor power.
Maximum motoring power.
Defines the maximum allowed power fed by the motor to the
inverter in percent of nominal motor power.
Maximum generating power.
(see page 113).
(see page 114).
(output of the process PID
2.
30.18 Minimum torque
2.
sel.
30.25 Maximum torque
2.
sel.
30.20 is active
30.22 is active
sel.
status, bit 0).
status, bit 1).
status, bit 2).
status, bit 3).
status, bit 4).
status, bit 5).
(11.02 DIO delayed status, bit 0).
(11.02 DIO delayed status, bit 1).
Def/FbEq16
1
2
5
6
on page 88). -
-300.0%
See par.
46.03
300.0%
See par.
46.03
Torque limit
set 1
0
1
2
3
4
5
6
7
10
11
on page 88). -
300.00%
1 = 1%
-300.00%
1 = 1%